• Product Description
  • Technical Literature

Product Description

  • Case Study
  • Project Profile

DETAIL FABRIC is a polypropylene, staple fiber, needle-punched, nonwoven geotextile fabric. The fibers are needled to form a stable network that retains dimensional stability relative to each other. The geotextile is resistant to ultraviolet degradation and to biological and chemical environments normally found in soils.

USES DETAIL FABRIC is designed for end lap applications of PRECON® and PRECON LOW TEMP from W. R. MEADOWS. The use of DETAIL FABRIC will create a waterproof and vaporproof shield that will help resist moisture penetration through ends laps of PRECON and PRECON LOW TEMP.

SCHEDULE A MEETING

REQUEST PRODUCT LITERATURE

Technical Literature

  • Case Study
  • Project Profile

Data Sheets

  • Product Data Sheet
  • Safety Data Sheet

Product Data Sheet

07 13 00
No. 713  
No. 713 
No. 713 

DETAIL FABRIC Nonwoven Geotextile Fabric

DESCRIPTION DETAIL FABRIC is a polypropylene, staple fiber, needle-punched, nonwoven geotextile fabric.  The fibers are needled to form a stable network that retains dimensional stability relative to each other. The geotextile is resistant to ultraviolet degradation and to biological and chemical environments normally found in soils.

USES DETAIL FABRIC is designed for end lap applications of PRECON® and PRECON LOW TEMP from W. R. MEADOWS.  The use of DETAIL FABRIC will create a waterproof and vaporproof shield that will help resist moisture penetration through ends laps of PRECON and PRECON LOW TEMP.

FEATURES/BENEFITS

  • Superior chemical resistance.
  • Sturdy fabric capable of withstanding construction installation stresses.
  • Maximum UV resistance.

PACKAGING 12″ x 120′ (300 mm x 36.6 m)

TECHNICAL DATA

PropertyTest MethodValueUnitResult
Grab Tensile StrengthASTM D-4632MARVlb. N115 512
Grab ElongationASTM D-4632MARV%50
Puncture StrengthASTM D-4833MARVlb. N65 289

  APPLICATION End Laps … Overlap PRECON membrane 6″ (152.4 mm).  Prior to overlap, apply BEM, HYDRALASTIC 836, or MEL-ROL® LIQUID MEMBRANE (two-component) from W. R. MEADOWS in area to be lapped.  Roll press membrane into BEM, HYDRALASTIC 836, or MEL-ROL LIQUID MEMBRANE.  At terminations of membrane, apply BEM, HYDRALASTIC 836 or MEL-ROL LIQUID MEMBRANE 12″ (31 cm) wide centered over the termination and while still wet, embed 12″ (31 cm) wide DETAIL FABRIC into the HYDRALASTIC 836 or MEL-ROL LIQUID MEMBRANE and roll press into place.  Ensure that DETAIL FABRIC is centered over the termination with 6″ (15.2 cm) on each side of lap edge.  Apply additional HYDRALASTIC 836 on all terminations of DETAIL FABRIC.

LEED INFORMATION May help contribute to LEED credits:

  • EA Credit 1: Optimize Energy Performance
  • IEQ Credit 3.1: Construction Indoor Air Quality Management Plan – During Construction
  • IEQ Credit 7.1: Thermal Comfort – Design
  • MR Credit 2: Construction Waste Management
  • MR Credit 4: Recycled Content
  • MR Credit 5: Regional Materials

Material last updated August 2013.

Technical Literature

Data Sheets

  • Product Data Sheet
  • Safety Data Sheet

Next Steps

Locate a DistributorTechnical SupportContact Us